Lots going on here; this guitar came in and needed all the hardware swapping for black, new Seymour Duncan pickups installed with a full re-wire with coil taps, a black TUSQ nut and I found the frets were uneven and in need of a fret level.
I generally use Gotoh parts and other than the tuners (Grovers, supplied by the owner) and this was the case here. When removing the bridge posts there was a bit of chip out on the paint so I added some washes that are quite discreet. I had to plug the tailpiece stud holes as the Gibson ones are so big! I was a good job also as when I checked it was not in the correct place.
The frets were uneven and the 3rd was actually bent. I managed to level this out but I wonder if this came out of the factory like that as I couldn’t see any signs of damage.
Setup with supplied Elixir 10 – 46
